Pirelli Hose Wire

This product is a brass coated steel wire used for reinforcing high pressure hose.
The wire diameter range is from 0.20mm. trough 0.71mm;as per the steelcord production process severe quality controls are applied during all production phases.

Raw Material
Hose reinforcement wire is an hard drawn,high Carbon steel wire made with the same rod quality of steelcord.

Welds
Welds minimum breaking load must be 40% of wire breaking load.
Welds diameter may exceed the wire diameter by maximum 20%.

Identification characteristics
An hose wire product is normally identified by the nominal diameter & tensile strength.

 
 
Diameter
Breaking strength
Linear density
0.20 MM (2750-3050)
91
0.247
0.20 MM (3050-3350)
97
0.247
0.22 MM (2750-3050)
110
0.298
0.25 MM (2750-3050)
142
0.385
0.30 MM (2450-2750)
184
0.555
0.295 MM (2450-2750)
177
0.536
0.30 MM (2750-3050)
205
0.555
0.28 MM (2750-3050)
178
0.484
0.25 MM (2450-2750)
127
0.385
0.35 MM (2450-2750)
250
0.755
0.38 MM (2750-3050)
328
0.89
0.38 MM (2450-2750)
295
0.89
0.50 MM (2450-2750)
510
1.542
0.50 MM (2750-3050)
569
1.542
0.56 MM (2450-2750)
640
1.93
0.56 MM (2750-3050)
715
1.93
0.60 MM (2450-2750)
735
2.219
0.71 MM (2450-2750)
1029
3.11
0.65 MM (2450-2750)
862
2.524
0.65 MM(2750-3050)
961
2.615
0.80 MM (2450-2750)
1305
3.945