It's important to have the proper air pressure in your tires, as
underinflation may lead to tire failure. The right amount of air for your tires
is specified by the vehicle manufacturer & is shown on the vehicle door edge,
door post, glove box door or fuel door. It is also listed in the owner's manual.
1. When you check the air pressure, make sure the tires are cool - meaning
they are not hot from driving even a mile. (NOTE: If you have to drive a
distance to get air, check & record the tire pressure first & add the
appropriate air pressure when you get to the pump. It is normal for tires to
heat up & the air pressure inside to go up as you drive. Never "bleed" or
reduce air pressure when tires are hot.)
2. Remove the cap from the valve on one tire.
3. Firmly press a tire gauge onto the valve.
4. Add air to achieve recommended air pressure.
5. If you overfill the tire, release air by pushing on the metal stem in the
center of the valve with a fingernail or the tip of a pen. Then recheck the
pressure with your tire gauge.
6. Replace the valve cap.
7. Repeat with each tire, including the spare. (NOTE: Some spare tires require
higher inflation pressure.)
8. Visually inspect the tires to make sure there are no nails or other objects
embedded that could poke a hole in the tire & cause an air leak.
9. Check the sidewalls to make sure there are no gouges, cuts, bulges or other
irregularities. NOTE: Air pressure in a tire goes up (in warm weather) or down
(in cold weather) 1-2 pounds for every 10 degrees of temperature change.
